2u Letterbox brush panels enable neat routing of cables form the front to rear of data cabinets, helping with air-flow and preventing hot air from re-circulating.
Cable management dump panels, with individual fingers and rear cable pass through slots, allows you to neatly direct patch cables from the front to rear of cabinets. The removeable front cover allows easy access to network cables and when fitted protects them from damage.
Flexible HDMI Male to HDMI Female adaptor bends up to 270° and rotate up to 360°. Ideal for when space is tight to releve cable stress ie: when wall mounting a TV.
USB4™ is the most recent update in the USB evolution. With a maximum bandwidth of 40Gbps, this is double the previous best spec of 20Gbps (USB3.2 Gen 2x2).
Black cantilever shelf, designed to fit standard 19" wide wall mounted switch cabinets. 1U, 200mm deep with vent holes to improve air circulation to aid cooling of equipment.
2U cable management dump panels are the straightforward way for keeping networking cables tidy in data cabinets. The individual fingers and brush strip cable pass through slots, allows you to neatly direct patch cables from the front to rear of cabinets.
5Gbps USB 3.0 Active Extension Cable. Extends the signal up to a maximum of 13 metres.
These 2U Brush Strip Panels are seperated in to 2 1U sections and are the easy way to manage network cables in your data cabinet.
For cable bundles of 25-130mm, this solution is ideal for tidying and routing bundles of voice/data and power cables and can be easily be cut to length. *Cables for display only not supplied*
Large range of Extension Power Cables are available next day from our local stock. IEC320 C19 to C20 V-Lock power cables. Prevent inadvertent disconnects by securing a C19 to the C20 outlet when the PDU contains the corresponding notched outlets. Most Schneider APC, Panduit, Enlogic, and NextGen HP PDUs are fitted with these outlets.
Large range of Extension Power Cables are available next day from our local stock. IEC320 C19 to C20 V-Lock power cables. Prevent inadvertent disconnects by securing a C19 to the C20 outlet when the PDU contains the corresponding notched outlets. Most Schneider APC, Panduit, Enlogic, and NextGen HP PDUs are fitted with these outlets.
Large range of Extension Power Cables are available next day from our local stock. IEC320 C19 to C20 V-Lock power cables. Prevent inadvertent disconnects by securing a C19 to the C20 outlet when the PDU contains the corresponding notched outlets. Most Schneider APC, Panduit, Enlogic, and NextGen HP PDUs are fitted with these outlets.
DisplayPort is a 20 pin connector similar to HDMI but designed to replace DVI/VGA. Our DisplayPort to VGA adapters are the perfect solution for adapting your DisplayPort computer or graphics card to use a VGA monitor/device. Due to restrictions of VGA this adapter cannot carry audio.
Black cantilever shelf, designed to fit standard 19" wide wall mounted switch cabinets. 1U, 300mm deep with vent holes to improve air circulation to aid cooling of equipment.
These Low Smoke Zero Halogen (LSZH) power cables are manufactured for enhanced performance and fully tested to conform to UK standards. They are commonly used to either extend an existing C19 - C20 power cable, or to connect directly from a Power Distribution Unit (PDU) or UPS to any active hardware and server equipment with C19 inlets.
19" 2U cable management bar with 100mm rings, enables neat routing of networking cables.
Embedded clock architecture to reduce EMI susceptibility Supports resolutions greater than QXGA (2048 x 1536) at 24-bit colour depths Supports existing VESA and CEA standards Supports hot plug detection as well as link status failure Supports a minimum of 1080P resolution at 24bpp, 50/60 Hz at 15 metres Supports display port signal to VGA signal Supports...
The mini DisplayPort to VGA adaptor will allow you to connect a high definition monitor, projector or LCD TV to a MacBook, MacBook Pro or a MacBook Air with a mini DisplayPort connection. Mini DisplayPort male to VGA male Mini display port 1.1a compliant (5.4Gbps) Triple 10-bit, 162 Mhz video DAC for VGA signal Supports up to 1080p, 1920 x 1200 resolution
OS2 LC Ruggedized Flat Twin Patch Cables for critical installations. 9x Stocked options, available immediately in UK Stock from 5 Metre to 50 Metre lengths. Each cable is individually tested and then bagged with test results. Popular LC - LC termination for panel to panel or panel to switch fibre patching.
Perfect solution for adapting your DisplayPort Computer or Graphics Cards to use a VGA Monitor/Device.
Connect your USB-C device to your VGA monitor, projector or Television. Compatible with the latest MacBooks, Chromebooks, mobile phones and any other device that has a USB Type C output. Available in 1, 2, 3 and 5mtr lengths.
All Patchsave power extension blocks are surge protected and you also have the option of individual switched sockets on most configurations. The trailing UK Plug lead is available in a 2, 3, 5 or 10 Metre variant. From local stock we can offer 1 Way, 2 Way, 4 Way, 6 Way extension blocks and also 8 Way and 10 Way Tower units.